Criterion PF219#

Sleep furniture and items (such as cots, beds, stretchers or mattresses): 

• allow children using them to lie flat;
• are of a safe design and arrange so that:
  • adults have clear access to at least one side length-wise;
  • there is sufficient air movement to minimise the risk of spreading illness in the area surrounding each child; and
  • children can sit or stand safely as they wake.

Guidance#

How to show you are complying#

You must provide sleep furniture and items intended for children to sleep on—such as cots, beds, stretchers, or mattresses—that allow children to lie flat and are designed to support their safety. 

These items should be arranged and spaced so adults have clear access to at least one full side, allowing them to check on children easily, monitor their breathing and temperature, and respond quickly in emergencies. This spacing will also help to maintain air movement to reduce the risk of spreading illness and easy access, so that they do not disturb each other.

Current health advice recommends providing approximately 1.4 m² for large, free-standing cots.

Sleep furniture must be assessed for safety based on the child’s developmental stage (mobile or non-mobile), the height of the furniture (beds must be less than 700mm above the floor), and the potential for hazards such as strangulation, choking, or limb entrapment. Items that do not meet these requirements cannot be used.

Cots

Cots are suitable for infants and must be enclosed on all four sides to prevent falls. You should ensure cots have no gaps, protrusions, or sharp edges that could trap an infant or catch clothing. The sides must be high enough to prevent climbing and free of footholds. Cots should be sturdy, allow good airflow, and be easily washable. Mattresses must fit firmly inside the cot to avoid gaps and should not be too soft, as this poses a suffocation risk.

Multi-level cots (stacker cots)

While multi-level cots are not likely to be used in home-based settings. If they are then multi-level cots may only be used if specific conditions are met. You must ensure that each cot is well ventilated to prevent the build-up of carbon dioxide, moisture, and heat. Cots must be securely fixed to the wall and easily accessible to staff, with sufficient separation to prevent cross-infection. Children who can sit must be able to do so safely in the lower level.

Multi-level cots must only be opened from the outside by an adult. They must have no gaps, protrusions, or sharp edges, and the sides must prevent climbing. Mattresses must fit firmly and not be too soft. Children who are able to sit or stand must not be placed in the upper level, as they may fall or be injured. Once children are too large or mobile, they must be moved to a single-level cot, stretcher, or bed.

Portable cots

You may use a portable cot in a home-based setting only if it is for a single child. The cot must meet the Australian/New Zealand Standard AS/NZS 2195:2010 (Folding Cots), have a mattress covered in non-porous material, and be suitable for safe sleep. Because portable cots are made from textile or mesh materials, they cannot be adequately cleaned for use by multiple children. You must not place children who are able to stand in a portable cot, as they may cause it to tip over and risk injury.

Stretchers and mattresses

Mattresses must be firm and between 20 and 24 centimetres deep, so the mattress does not present a suffocation risk to infants.

Stretcher fabric must remain taut and be monitored for wear to prevent sagging over time. Inflatable mattresses are not permitted, as they can smother a child’s face.

Cots are the preferred option for infants, as it is challenging to sustain sufficiently warm temperatures at floor level for sleeping infants on a mattress.

Beds

Beds are single-level sleep furniture with the mattress surface less than 700mm above the floor. There should be no gaps between the bed frame and the mattress that could trap or wedge a child. Children should be able to get in and out of beds independently. Infants must not be placed in beds, as they may roll off.

Bunk beds and elevated beds

Bunk beds and elevated beds, where the mattress surface is 700mm or more above the floor, cannot be used. These pose a falling risk and do not meet the design requirements for child safety. Increasing supervision or using safety matting does not mitigate this risk or meet the criterion.

Transport items

Items designed for transportation—such as slings, backpacks, prams, buggies, and car capsules—must not be used as sleep furniture. These do not allow children to lie flat and are not designed for safe sleep.